
Chapter 60: TL EveryPhase 299
Side-Chain Input
When the Side-Chain Input selector (the key
icon) is enabled, the audio for the Envelope De-
tector is taken from the side-chain input rather
than the current track. Select the Side-Chain In-
put using the Pro Tools key icon at the top of the
plug-in window.
Threshold
The Threshold slider sets the amplitude level re-
quired for the Envelope Detector. The LFO En-
velope Detector light blinks brighter when audio
is detected above the threshold.
Attack
The Attack slider sets the attack rate of the
Envelope Detector.
Release
The Release slider sets the release rate of the En-
velope Detector.
Using TL EveryPhase
This section addresses some common scenarios
in which TL EveryPhase can be used during a
Pro Tools session.
Using TL EveryPhase Presets
TL EveryPhase ships with a wide selection of
factory presets for different phaser sounds. The
following should be noted when using presets:
• Presets which use the Envelope Detector
may need to have the Envelope Threshold,
Attack and Release adjusted appropriately
for the current audio signal.
• Some presets utilize the Side-Chain Input.
If necessary, ensure that you have a side-
chain input assigned, and adjust the Enve-
lope Detector to get the best results.
• Adjust the input and output levels appro-
priately for your track to avoid clipping.
Creating a Single Phased Sound
with TL EveryPhase
A single phased sound (one cycle of the phaser)
can be created using automation of the LFO
manual trigger.
To create a single phased sound:
1 Insert TL EveryPhase on a track.
2 Select an appropriate LFO Waveform, such as
Ramp.
3 Set the Rate to an appropriate value.
4 Enable the LFO Single trigger so the LFO will
only cycle once.
5 Select the Auto button at the top of the
TL EveryPhase plug-in window.
6 Add LFO Manual Trigger to the automation
list.
Side-Chain Input selector enabled
Comentarios a estos manuales