Waves Plug-in for Vocals and Monophonic Manual de usuario descargar pdf (Pagina 20)

UltraPitch Manual

Chorus

You can obtain a very ‘fat’ chorus effect by imitating two voice/tones in a very close but unequal pitch. Use

the following settings for this effect (using the three or six voice component):

1 Set the vocal/instrumental pitch-detection mode as described in the Quick Start chapter.

2 Set all voices ‘on’.

3 Set all voice mix levels to -6dB.

4 Set voices to various pitch shift degrees in the range 1 to 10 cents

5 Set all voice formant degrees to zero.

6 Set voice panning angles to various angles between -45 and +45 degrees.

7 Set voice delays to various values between 1ms and 3ms.

8 Set ‘Animate’ to a value between 1ms and 3ms.

9 Set the ‘Direct’ level according to the effect mix required.

Other chorus effects

For a more varied chorus effect, try the following:

1 Set the vocal/instrumental pitch-detection mode as described in the first section of the Quick Start.

2 Set all voices ‘on’.

3 Set all voice mix-levels to -6dB.

4 Set all voices to various pitch shift degrees in the range of 5 to 20 cents.

5 Set voice formants to different values between -0.2 and +0.2.

6 Set voice panning angles to various angles between -45 and +45 degrees.

7 Set voice delays to various values between 10ms and 30ms.

8 Set ‘Animate’ to a value between 10ms and 30ms.

9 Set the ‘Direct’ level according to the effect mix required.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Sin comentarios

Waves Plug-in for Vocals and Monophonic Manual de usuario Pagina 20